65-73 Mustang JBA Long Tube Headers 1-5/8 in SS Ceramic Coated - Borgeson Power Steering Conversion Kit

JBA Ceramic Coated Stainless Steel 1-5/8" Long Tube Headers for: 1965, 1966, 1967, 1968, 1969, 1970, 1971, 1972 and 1973 Mustangs with a 260, 289, 302 and Borgeson Power Steering Conversion Kit or 71 - 73 Mustangs with 351W Engine and Borgeson Power Steering Conversion Kit.

After the installation of a Borgeson Power Steering Conversion Kit, you may run into header clearance issues. Not to worry, JBA's long tube headers are created specifically to clear the Borgeson setup while providing a fantastic boost in performance and sound. This set of headers will fit your 1965-1970 Mustang equipped with the Ford factory small block engines; 260, 289, 302. These will only fit 71-73 Mustangs with a 351W engine block.

Headers Feature:

- Stainless steel flanges and tubes
- Silver ceramic high temp coatings (for reduced heat in engine compartment and excellent appearance) 
- 3/8" thick CNC laser cut flanges
- 1-5/8" primary tubes
- JBA Firecone style collector
- Includes all necessary hardware and gaskets for installation

Important Installation Notes:

1) Will Not fit P-Heads
2) Matching Mid-Pipes are now Available
3) Fits 5 Speed Transmissions with aftermarket cross members
4) Fits Ford AOD (Automatic Over Drive) Transmissions
5) Does Not Fit 71-73 Mustang Factory 4 Speed clutch linkage
6) Will work with the factory Z Bar or Hydraulic Clutch for manual transmissions

The stainless steel construction already resists rust, but JBA coats the headers with silver ceramic coating to help contain heat and provide great aesthetics. With the ceramic coating, you don't have to worry about the finish flaking off or discolored metal. All the required hardware is included as well as high-quality gaskets so you don't need to make any trips to the local automotive parts store. JBA's long tube headers have 3/8" thick flanges which resist warping due to the heat. The flanges are CNC laser cut to ensure a perfectly flat surface so your cylinder heads seal perfectly against the headers. 1-5/8" diameter mandrel-bent stainless steel tubes increase exhaust gas flow for a great improvement in power. JBA's patented Firecone collector merges individual cylinder exhaust gases without interrupting flow and velocity.

As with all JBA performance headers, you'll witness increased horsepower and torque throughout the entire RPM range. Improved throttle response will make your Mustang a joy to drive. This long tube headers will help the engine breathe and increase fuel economy due to increased efficiency. To top it all off, these headers will look great under the hood of your 1965-1973 Mustang.