67 - 68 Mustang Power Window Kit Crank Handle Switch

This kit comes with everything you need to convert from those manual crank windows to a custom power window setup with power crank handle switches that reuse your original window crank handles. The kit comes with new power regulators featuring AC Delco motors for the front windows, power crank handle switches for original window cranks, a complete and labeled wiring harness, as well as conduit to protect the wires traveling through the doors.

The new power window regulators are bolt-on and bolt directly into the original mounting holes with little to no modifications and will use the original glass channels. You can count on these new power window regulators to last because they are built right here in the USA. Constructed from 1018 cold roll steel with bronze Oilite thrust bearings at all the pivot points and feature treated gear plates for longer teeth life. Each window regulator is equipped with a new AC Delco OEM motor, insuring the highest of quality and performance every time you hit the switch.

This kit includes power crank handle switches that are controlled by pushing down on the crank handle to lower the window and pulling up on the crank handle to raise the window. These crank handle switches mount behind the door panels and allow the use of original window crank handles. The original window cranks mount directly on to the new power crank handle switches the same way they would mount on to the factory manual window regulators.

The wiring harness comes with all the wires labeled for correct positioning and are fused to allow operation of the power windows without the engine running. The black wire is the ground and should be attached to clean metal to ensure a proper ground. The red (orange) wire is the 12V hot feed.

Kit Includes: