67 - 70 Mustang RideTech Front Control Arms

What says ?performance? more than a set of tubular control arms! After all of the time and effort expended on your ride, you definitely can?t let your stamped oem control arms detract from all that work. Finish your suspension off with these new tubular control arm systems from Ridetech. Built with all of the care and experience you have come to expect from us, these tubular control arms are a precision engineered solution for ShockWave? installation, ball joint binding, and frame clearance issues that can haunt some vehicles. When you combine the performance benefits with the elegant design of these arms, there is no question.... You want these.

StrongArms are optimized to allow proper camber adjustment at your new lowered ride height without using a large stack of shims.

All STRONGARMS include ball joints, and bushings. They are bolt-on: ready to install!

Front Benefits:

? Eliminates the Strut Rod

? Where the factory strut rod uses a rubber bushing to attach to the car we use a bearing setup. The bearing setup gets rid of the compression that is experienced with hard braking and cornering.

? RideTech's upper control arm cross shaft lowers the pivot point. By lowering the pivot point of the upper control it increases the camber gain, this helps keep the tire flat on the road surface when you are going through hard corners. This is all done with no additional drilling, the drop is built into the control arm cross shaft.

? The lower arm uses an eccentric eliminator. This plate has multiple positions to be used in aligning the car, and once they are set you do not have to worry about your alignment moving. Any fine tuning that is needed, can be done with the upper control arm because it is fully adjustable.